Used CEFLA / DELLE VEDOVE CV 515, KAV 45, DV TSL 16-6, AD 812 Vacuum Coat Finish Line with Sander, Unloader and Gate Cutter.

ONLY 40 HOURS ON THIS LINE 

Bought for $ 240,000 - One owner

222" (5638 mm) Maximum workpiece length

12" (305 mm ) Width capacity

16" (407 mm ) Min. part length

2" ( 50 mm ) Max. part thickness

1" ( 25.4 ) Min. width

½" ( 12.5 mm ) Min. thickness

32 - 98.4 FPM (10 - 30 m/min.) Variable feed speed

KAV 45

Sanding Unit:

(5) Brush sanding units configured: Bottom, left, right, top, top.

(7) Material feed rollers positioned to create counter pressure at sanding head locations

(4) Posts each side (8 total) supporting holddown and side rollers with adjustable arms

at infeed with adjustable arms for positioning of the workpiece

Sanding heads on dovetail glide with hand crank adjust and SIKO counters and tilt.

UV Vacuum coater:

(2) 15 HP Vacuum pumps

3 or 4 Sided coating

100% Coating efficiency

Substrate enters vacuum chamber via 6' conveyor belt & passes under the coating as the substrate leaves the chamber negative pressure in the chamber keeps excess fluid inside. Coating is run through several filters and sent back to the reservoir for use again. 

15 Gallon cap. reservoir

Stainless steel vacuum chamber with adjustable substrate guides and guides

Air operated diaphragm recylcing pump

High cap. fluid filter

Separation tower with stainless steel baffle & filtering system

Heavy gauge steel construction

Free-standing operator panel

Coating thickness controlled with a modulating valve and vacuum pressure gauge

Uses UV coatings be it stains, primers, sealers, base coats or top coats

Can be used to coat most solid materials, regardless of profile.      

Ultra-Violet Cure Oven:

360° Instant polymerization of photosensitive coatings with intricate or simple shapes

(4) 12" Lamps (5 lamps originally): (3) Bottom and (4) top/sides

Adjustable 400 WPI lamps.

Lamps are mounted on adjustable supports to optimize UV exposure to any profile

Cooling fans mounted on each lamp to maintain optimal working temperature.

DV/TSL 16-6 Automated Unload Unit:

Designed to semi-automatically unload linear profile workpieces

(10) Transfer support arms

Roller infeed section with variable drive 

1st and 2nd Transfer arms adjusted to accept smaller part sizes.

Parts leave the oven onto this receiving rollers.  When the part is completely on receiving table, confirmed by an electric eye, the rollers drop down so the transfer belts can move the part laterally for unloading or onto a return conveyor.  Necessary component if smaller parts are run and manually offloaded.  

AD812 CNC Gate Cutter

Cuts templates for vacuum coater matching profile of parts.

For any additional questions, freight or financing contact:

Paul Rhoades at (704) 821-1402 or Toll Free at (866) 811-1411

Email:
paul@machineking.com