USED BRANDT ( KDN 340 ) EDGEBANDER

Brandt Edge Bander KDN-340 with 3mm Capacity

0.4-3mm (1/8") Edge thickness capacity

8-45mm panel thickness

60mm  (2.36") minimum panel width

140mm (5.51") minimum length

Equipped with infeed heating shoe to pre-heat panel edge

Hot melt granulate glue system w/fast start-up (10-12 min heat up)

W/reversible rotation glue applicator roller & automatic reduction glue temperature adjustment

(when idle drops to 150 degrees it takes 2-1/2 min to re-activate)

3mm PVC pneumatic guillotine for coil cutoff

Automatic feed magazine

Coil stock feeds automatically w/guillotine cutoff

All strip stock are fed automatically through strip feed magazine

(2) Roller pressure section (1st driver, 2nd idle)

w/electronically controlled & feed speed synchronized drive roll

Vertical travel double motor front & rear end trim with 0-15 degree horizontal.

Bevel capacity (.25-12,00 RPM motors)

Top & bottom flush/bevel trimmers (.35HP - 12,000 RPM motors,) bevel 0-15 degrees

Top & bottom PVC scraping unit for up to 3 mm radius

Top & bottom buffing unit (.15 HP - 2,750 RPM motors)

Feed speed of 30 FPM

Equipped with operator control panel at eye level

Automatic height adjustment w/top pressure beam for all workstations

Electronic line control (no limit switches)

Digital height indicator on hold down beam

Electronic motor brakes on trimmers