Automatic Edgebander with Pre-Mill & Corner Round Stations

Specifications:

5/8" (15 mm) Edgebanding thickness cap.

10 - 55 mm Panel thickness

2-3/8" Min. panel width

5" - 8" Min. length

Dual feed speed of 39 & 59 FPM

Equipped with:

Automatic strip & coil feed magazine with 3 mm PVC guillotine

Granular glue system Teflon coated lower applicator glue pot

1" dia. glue applicator roller w/reversible rotation

Pressure section:

(1) Large dia. clutch controlled drive roller

(4) Pneumatic pressure idle rollers Independent adjustment of drive & idle rollers

Digital indicator.

Workstations:

Station 1: Equipped with: Universal Pre-Milling heads (2) with 2.8 HP-12,000 RPM motors, SIKO digital readouts.

Station 2: Front & rear end trims on diagonal travel guide system 0.75 HP - 12,000 RPM Motors tilt 0° - 15° on horiz. plane

Station 3: Top & bottom flush/bevel trims (0.8 HP - 12,000 RPM ea.) Digital readouts.

Station 4: Corner rounding unit for trimming leading & trailing upper and lower edges/corners for up to 3 mm PVC edgings, two (2) 0.7 HP - 12,000 RPM motors Each motor mounted on THK guides ensuring high quality finish Frontal & lateral copying devices Dust extraction and pneumatic blowers

Station 5: Top & bottom PVC scrapers for 3 mm radius Pneumatic pressure control for scraping knives

Digital readouts Hot air blower

Station 6: Top & bottom buffing (0.3 HP - 3,000 RPM motor ea.)

Units tilt 0° - 30°

Complete with:

Feed chain with white rubber pads 3 HP Drive.

Microprocessor for line control & glue temperature (can store up to 50 preset programs)

Insulated sound enclosure w/large window area

Rotating operator control panel at eye-level height

Telescopic panel support