Three (3) open stations for expansion

Power: 220/440v 3ph; 60hz.

Edgeband thickness cap. 0.4 - 3 mm

Min. panel width 55 mm (2 1/8")

Maximum panel thickness 60 mm (2.36")

Feed speed variable up to 18 to 32 m/min (59' to 104' FPM).

Hot melt glue system "A34" with reversible glue roller applicator

Pressure roll section with (1) large dia. driven & (2) idle rollers

Manual adjustment of pressure zone through SIKO digital counters for different edge thicknesses.

WORKSTATIONS: Pre-Milling Station with (2) 3.0 Kw motors (4.0 HP - 12,000 RPM each), 35 mm high.

End Trimming "HL-81" (2 x 0.25 HP - 200 Hz, 12,000 RPM each) to cut excess edge on the front & back of the panel

Open Space # 1999 of 600 mm (23-5/8") for adding rough trim station at later date.

Top & Bottom fine/profile radius trim unit, 0° - 30° tiltable, (0.4 KW - 12,000 RPM) each motor SIKO digital adjustment.

Open Space # 1999 of 600 mm (23-5/8") for additional working unit.

Open Space # 1999 of 600 mm (23-5/8") for additional working unit.

Buffing Unit, top & bottom # 4402 (0.25 kW - 2,850 RPM) each motor.

Line control with HOMATIC "PC 22" controller features

Function in Windows environment

Keypad w/LCD display

Fault diagnostic, etc.

Diagnostic analysis from HOMAG service support via Modem.

Complete with:

SIKO Digital adjustments

Electronic DC brakes on all trim motors

Sound cabin for all workstations

Adjustable outboard panel support with swing out arms for up to 800 mm (31.5")

80 mm feed track pads, and V-groove belt on top pressure beam which manually adjusted.