Used Brandt kdn 350 Edgebander with Corner Rounding

Edge capacity: 0.4 - 8 mm (5/16")

Panel thickness 15/32" - 2-5/32"

Min. panel length 160 mm (6-3/8") and 65 mm (2-1/2") min. width

Line control (NO limit switches) for workstation function.

PC-16 Program Control with 7-1/2" VGA screen

8 MB IDE flash disk

8 MB RAM

Internal Modem for remote diagnostic link

Signal infeed light to insure proper spacing between panels.

Glue applicator roller is reversable and retractable from the fence line.

Automatic magazine for strip & coil.

3 mm PVC guillotine

(1) drive plus (1) split secondary roller pressure sections.

Workstations: End trim (1/3 HP - 12,000 RPM motors) chamfers 0° - 15° via programmable controller

Top & bot. flush/radius trim, bevels 0° - 15° (1/2 HP - 12,000 RPM motor)

Top & bottom scraping for 3 mm radius with servo control indexing system

Single motor corner rounding.

Top & bottom buffing (0.25 HP - 2,800 motors).

End trim & flush trim stations have HF motors w/electronic brakes

Feed chain track speed 36 FPM,

2 HP feed drive.

Complete with:

Operator control panel w/PLC (Programmable Logic Control) keypad & LED readouts

Used tooling.

Click here for Lease Application

Click here for Financing information

Scoll down for a freight quote

Click her to sell your equipment - the listing form is at the bottom of the page