Feed Thru Drilling Machine equipped as follows: (2) Horizontal drilling heads one on the right & one on the left each with 20-spindles @ 32 mm centerdistance each with 1.8 HP motor & 3,000 RPM

(6) Six lower vertical drilling units each with 2-motors of 1.8 HP that split apart front-to-back, each is equipped with 11-spindles drilling block @ 32 mm centerdistance. The drilling blocks rotate 360° with pneumatic locking at your desired location. 

(2) Two upper drilling units equipped as above with the split-heads & two 11-spindle drilling blocks. 

Additionally includes: Waste/chip extraction/aspiration belt;, (3) upper holddown clamps for securing material & holding flat for the drilling cycle; "Quick Change" drill bit holders. 

 (6) models available in this liquidation